Connections; Power Cable; Gyro Signal; How To Attach Nh Connector To Signal Cable - Furuno FAR-2835S Installation Manual

Connections

Power cable

Connect the power cable to the filter at the right
hand side of the display unit. Cover the filter ter-
minals with the terminal caps (supplied) to insu-
late the terminals.

Gyro signal

Solder the 5 pin and 3 pin VH connectors (supplied) to the gyrocompass cable. Plug in the
connectors on the GYRO CONVERTER Board. For further details, see page 4-2.
GYRO CONVERTER
Board

HOW TO ATTACH NH CONNECTOR TO SIGNAL CABLE

NH connector wire
NH connector
housing
1 Insert NH connector
wire into NH connector
housing.
2 - 8
Figure 2-15 Location of GYRO CONVERTER Board
Shrink tubing
20mm
2 Cut shrink tubing
in 20 mm lengths and
slip onto each wire.
Filter
Power
cable
Figure 2-14 Location of filter
inside the display unit
Rear panel
Solder
3 Solder connector
4 Heat shrink
to signal cable.
tubing with solder-
ing iron.