Engine Stop Switch - Polaris 600 Fusion Owner's Manual

OPERATION

Engine Stop Switch

n
Push down on the engine
stop switch (✪) to
ground out the ignition
and stop the engine
quickly. Pull the switch
up to the ON position to
allow restarting.
Throttle Safety Switch
n
The throttle safety switch is designed to stop the engine whenever all
pressure is removed from the throttle lever and the throttle cable or
valves do not return to the normal closed position.
WARNING
Operating the snowmobile with a faulty throttle safety switch can result in
serious injury or death in the event of an accident. If the throttle safety switch
does not shut off the engine during a carburetor/throttle system malfunction,
immediately push down the engine stop switch. Do not start the engine
again until the malfunction has been corrected by your dealer.
Test the throttle safety switch
system daily before operation.
1. Sit on the seat.
2. Start the engine and allow it
to idle.
3. Hold the throttle lever pin
stationary by exerting pressure on the pivot pin in the direction
shown in the illustration.
4. Apply a slight amount of throttle. A properly functioning switch
must shut down the engine.
78
✪