EGO CH2100E Operator's Manual page 5

◾
Save these instructions. Refer to them frequently
and use them to instruct others who may use this tool.
If you lend this tool to someone else, also lend these
instructions to them to prevent misuse of the product
and possible injury.
IMPORTANT SAFETY INSTRUCTIONS
◾
Save these instructions. This manual contains
important safety and operating instructions for EGO
56V Charger CH2100E.
◾
Before using the battery charger, read all
instructions and cautionary markings on the
battery charger, the battery and the product
using the battery.
WARNING:
When using electric appliances, basic
precautions should always be followed, including the
following.
◾
To reduce the risk of injury, close supervision is
necessary when an appliance is used near children.
◾
Only use attachments recommended or sold by
manufacturer.
◾
Do not use outdoors.
◾
For a portable appliance – To reduce the risk of
electrical shock, do not put charger in water or other
liquid. Do not place or store appliance where it can fall
or be pulled into a tub or sink.
CAUTION:
To reduce the risk of injury, charge only
lithium-ion rechargeable batteries. Other types of batter-
ies may burst, causing personal injury or damage.
SPECIFICATIONS
Charger Input 220-240V~ 50Hz 210W
Charger Output
3A 56V
Approximately 40 minutes for
BA1120E battery pack.
Approximately 80 minutes for
BA2240E battery pack.
Approximately 100 minutes for
Charging Time
BA2800 battery pack.
Approximately 115 minutes for
BA3360 battery pack.
Approximately 145 minutes for
BA4200 battery pack.
Optimum Charging
0°C-40°C
Temperature
Charger Weight 1.2 kg
DESCRIPTION
KNOW YOUR CHARGER (Fig. A)
1. Cooling Air Port
2. Mounting Slot
3. Electrical Contacts
4. LED Indicators
5. Wall Mounting Holes
OPERATION
HOW TO CHARGE THE BATTERY PACK
WARNING:
Do not use the charger outdoors or
expose it to wet or damp conditions. Water entering the
charger will increase the risk of electric shock.
NOTICE: Lithium-Ion battery packs are shipped partially
charged. Before using it the first time, fully charge the
battery pack.
1. Connect the charger to the power supply
(220-240V~ 50Hz).
2. Align the raised ribs of the battery pack with the
mounting slots in the charger; slide the battery pack
down onto the charger as Fig. B shown.
3. The charger will communicate with the battery pack to
evaluate the condition of the battery pack.
4. When the battery pack is charging, the green LED
on the charger will flash. The power indicator on the
battery pack will flash in sequence: red, orange and
green. The fan in the charger continuously works to
cool the battery pack.
5. When the battery pack is fully charged, the green LED
will stop flashing and will shine green continuously. The
power indicator on the battery pack will go out. Wait
until the cooling fan stops, remove the battery pack from
the charger and disconnect the charger from the power
supply.
6. The battery pack will fully charge if left on the charger,
but it will not overcharge. If the battery pack remains
on the charger for one month or more, it will perform
self-maintenance and drop to 30% charge capacity. If
this occurs, reinstall the battery pack on the charger
to recharge it fully.
NOTICE:
◾
A significantly reduced run time after fully charging the
battery pack indicates that the batteries are near the
end of their usable life and must be replaced.
◾
The charger may warm during charging. This is part
of the normal operation of the charger. Charge in a
well-ventilated area.
56 VOLT CHARGER — CH2100E
EN
5