Attaching The Mounting Cap And The Camera - Bosch AUTODOME IP 5000i IR Installation Manual

18 en | Installing a Roof Mount and Camera
4.
5.
6.
Figure 8.2: NDA-U-RMT
1
2
3
4
5
7.
8.
8.2

Attaching the Mounting Cap and the Camera

1.
2.
3.
4.
5.
2017.08 | 1.0 |
Attach the Parapet Wall Bracket using at least six (6) stainless steel fasteners, three (3)
on each side. (The bracket has eight (8) holes.) Be careful not to overtighten the
fasteners because it may strip the threads. If attaching the parapet mount to a flat roof,
attach the optional LTC 9230/01 Roof Mount Plate to the roof and then attach the
Parapet Wall Bracket to the Roof Mount Plate.
Insert the Parapet Pipe Arm into the mounting bracket until it bottoms in the bracket.
Remove the End Cap from the front of the arm. Feed the video, control, and power wires
up through the bottom of the pipe arm and out the front end.
End Cap with O-ring
Parapet Pipe Arm
1/4-20 SS Cap Screw
Down Pipe
10-24 SS Pan Head Screw
Fold back the video, control, and power wires at the front end of the arm and route them
down and out through the Down Pipe. Replace the End Cap.
Wrap at least five layers of Teflon tape around the Down Pipe threads.
To ensure a watertight seal, wrap Teflon tape four times around the threads at the end of
the wall mount.
Attach the mounting cap to the wall mount.
Thread all connection cables through the mounting cap.
Attach the hook at the end of the Safety Tether to the loop attached to the top of the
camera.
Connect the mating connectors on the user-supplied cables to the matching connectors
on the camera. Refer to the chapter Connection for more information.
Installation Manual
AUTODOME IP 5000i IR
Bosch Security Systems