Output Cable Connection - Eastwood VERSA CUT60 User Manual

INSTALLATION
Input cable connection (enclose installing diagram)
1. Every machine has been disposed a power cable which must be connected to
coordinated voltage class in compliance according to input voltage of cutting
machine .If cutting machine whose power voltage is 220v is connected wrong to AC
380v ,that will cause components of inter-machine are burned up .
2. Make sure power cable is connected to power switch reliably and prevent from
oxidizing .
Make sure power voltage is inside the waved range .

Output cable connection

1. Make sure tube of pressed air is connected to copper connector by high pressure rubber
tube firmly .
2. Make sure copper screw of another end of torch is connected to electrify integration
terminal then tighten them clockwise relation (prevent from leaking gas) .Mobile plug
of another end of grounding cable pincer is connected to positive terminal of front panel
then tighten it .
3. Make sure air plug of torch is connected to switch connector of panel (If it is
arc-supporting cutter ,arc-supporting cable of torch is connected to terminal of
arc-supporting .)
CUT60 INSTALLATION