Installation - Eastwood VERSA CUT60 User Manual

INSTALLATION

The plasma cutter is equipped with power voltage compensation equipment. When
power voltage fluctuation
When the machine is used with long cables, in order to prevent voltage
down, bigger section cable is suggested. If cable is too long, it may affect the performance
of the power system. So we suggest you use cables of configured length..
1.Make sure the intake of the machine not blocked or covered to avoid the malfunction of
system.
2.Use cable (section not less than 6mm) to connect the housing and the ground. The way is
from the connecting screw in the back of the power source, or make sure ground firmly.
For absolute safety, both ways can be used.
3.Use pressure-resisting air pipe to connect the air intake and compressed air source, and
use hoop and other way to tighten the joint. Air source should supply suitable pressure,
flow and be dry. If your air source does not meet the above requirements, you
should consider using sole compressor of the right power and air-decompressing filter, in
order to supply suitable pressure and eliminate the impurity and moisture in the air.
4.Install the air-electricity system plug to the socket in the panel and fix it clockwise. Air
plug of the cutting torch and arc-keeping cable(forCUT80/100/160) should be connected
to relevant socket, and fix the screw.
5.Put the loop cable plug to the fastening socket,
and tighten clockwise, another terminal holds the
work piece.
6.According to input voltage grade, connect
power cable with power supply box of relevant
voltage grade. Make sure there is no mistake
and make sure the voltage is different among
permission range.
7.Connect the cable as the picture shows.
You can start cutting.
between±15% of rated voltage, it still can work normally.
CUT80/100/160 INSTALLATION
from going