Pairing With Bluetooth; Operation - Brookstone 321701p User Manual

PAIRING WITH BLUETOOTH

1. Prepare your device (e.g., smartphone) to pair using Bluetooth
making sure that the device is within 33 feet of the earbuds. Refer to
your device's owner's manual for information on using the Bluetooth
function.
2. Press and hold the earbud's ON/OFF Button until the Pairing Indicator
(on the back of the in-line controller) quick flashes blue, indicating that
the earbuds are in pairing mode.
3. On your device, search the list of available devices and select ANC
EARBUDS. Note that it may take a few seconds for the earbuds to be
listed as an available device. Depending on your device, you may have
to tap SCAN to update the device list. Consult your device's owner's
manual.
4. If prompted, type the password or PIN 0000.
A message will display on your device confirming that your device is now
paired/connected and the earbud's Pairing Indicator will slow flash blue
indicating that the device is paired.
The devices will remain paired, even after being turned off, until you
cancel the pairing. Consult your device's owner's manual for information
on cancelling pairing.
The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any
use of such marks by Brookstone is under license.
8
®
® ,
®

OPERATION

Button Operation
Long press 3 seconds
Long press 3 seconds
Short press
O
Short press
Short press
Press and hold for
approximately 2 seconds
Short press
+
Press and hold
Short press twice
_
Short press
Press and hold
Short press twice
Slide to ON or OFF
ANC
Switch
Function
Power on
Power off
Play/pause
Answer a call
End a call
Refuse call
Volume up by one step
Volume increases continuously
Play next track
Volume down by one step
Volume decreases continuously
Play previous track
Enter/Exit Noise Cancelling mode.
When ON, a green LED is visible
in the switch.
9