Removing The Motor; Removing The Mechanism Board; Removing The Flywheel - JVC MX-GA8 Service Manual

3.5.4 Removing the motor

(See Fig. 4 to 6)
(1) Slide the plastic cover in the direction of the arrow, and re-
move the three claws. Then remove the plastic cover.
(2) Remove the two screws D fixing the motor. Be careful to
grease's splash when the drive belt comes off.
(3) Unsolder the motor terminal.

3.5.5 Removing the mechanism board

(See Fig. 5)
(1) Unsolder the four solder parts a and the four solder parts b.
(2) Remove the two screws E attaching the mecha. board.

3.5.6 Removing the flywheel

(See Fig. 7 and 9)
(1) Remove the cut-washer at c from the capstan shaft, then
remove the flywheel.
When reassembling the flywheel, be sure to use new
washers as they cannot be reused.
1-18 (No.MB080)
D
Plastic cover
Claw
Fig.4
Capstan
washer
Fig.7
Motor
terminal
Solder
E
part b
Solder
part a
Motor
Drive belt
Fig.5
Drive belt
Fig.6
Flywheel
Fig.8
Sleeve
Washer
Fig.9
Solder
part a E
Mecha. board
Drive belt
Motor
Drive belt
FR belt
c
FR belt