Removing The Motor Board - JVC HX-Z10 Service Manual

3.2.4 Removing the motor board

(See Fig.10 , 11)
• Prior to performing the following procedure, remove the servo
control board.
(1) Turn over the body and remove the two screws D. Move
the CD module bkt. in the direction of the arrow to release
two joints f.
(2) Unsolder the four soldered parts on the motor of the motor
board.
Caution:
If removing the motor board with the motor, you should
remove the screws attaching the motor from top of the
body(Refer to another section).
(3) Remove the two screws E attaching the motor board.
(4) Remove the spacer fixing the motor board and tray switch
board, and disconnect connector
(5) Disconnect the card wire from connector
board.
Caution:
When reconnecting the card wire, let the card wire through the
slot g of the motor board and attach it to the bottom of the body
using a double tape.
1-20 (No.MB014)
CN2 on the motor board.
CN1 on the motor
f
D
Fig.10
Spacer
Soldering point
E
CN2
CN1
g
Fig.11
f
CD Module
braket
D
E
Motor
Double
face tape
Card wire