Cables - Invacare Storm4 Service Manual

Invacare® Storm4 Series
4.
You see strip fuse (2) once fuse holder (1) is open.
5. If strip fuse has blown, first ascertain and rectify cause
of fault.
6. The main fuse may only be replaced once fault has been
rectified.
7. Remove strip fuse nuts (3).
8. Replace strip fuse.
Make sure to press two parts of fuse holder
shroud together until it snaps.
If older fuseholder version is used, lock fuse
holder with UL94V0 cable tie.
Installing main fuse
1. Refit all parts in reverse order.
2. Check all mobility device functions.

6.9.19 Cables

Checking
• 4 mm Allen key
• Oblique pliers
• Cable ties
1. Remove rear and center shroud. See 6.8.1 Replacing
rear shroud, page 38 and 6.8.2 Replacing center shroud,
page 38).
2. Pull batteries out of battery compartment. See 6.9.14
Making batteries accessible, page 46.
3.
Check fuse cable (1) and battery cable (2) for visible
damage and crushing points.
4. Replace any damaged cables.
5. Check all cables for visible damage and crushing
locations. Replace any damaged cables.
6. Pull each plug (1) carefully. The plug should not come
out of socket.
7. If one of plugs is loose, press it back into socket with
light pressure. The plug must engage.
8. Make sure that plug is now firmly in socket. If not,
repeat previous operation.
9. Refit parts in reverse order.
10. Check all mobility device functions.
48
Installing
Pay attention to "Installing on lifter column type B" if
a type B lifter column is installed.
• 4 mm Allen key
• Oblique pliers
• Cable ties
1. Remove rear and center shroud. See 6.8.1 Replacing
rear shroud, page 38 and 6.8.2 Replacing center shroud,
page 38.
2. In case of lifter cabling, remove also front shroud. See
6.8.3 Replacing front shroud, page 39.
3.
Lead cables on power module and actuator module
fitted at rear through recess in battery flap under
actuator module to cable bridge (1).
4. Lead cables inside shrouds over cable bridge (1).
5.
Fasten cables with cable clamps (2). Cable clamps on
front side of battery compartment for cables lifter
(optional) are not seen in picture.
6. Motor cables fitted with protection shrouds (2) are
guided out of front shroud through recesses on side.
7. Cables that lead to seat (upper actuator module, remote,
headlight), are guided out of front shroud through an
upper left recess (3).
8. Make sure cable has enough play so that all movable
parts can move freely without stretching, clamping or
abrading cable.
9. Lay cables in same way under seat and to remote.
Fasten cables with prescribed cable clamps or cable ties
respectively.
Installing on lifter column type B
If a type B lifter column is already installed, start directly at
chapter "Installing on type B lifter column - part 2".
1533060-M