Assembling A Hardware; Wiring Power Supply - Omron NA-series Startup Manual

3-2

Assembling a Hardware

Connect and wire all the units that are used in the system configuration. This section provides an over-
view of assembling methods. For the details and precautions for safety, refer to manuals for each
device.
Precautions for Safe Use
In order to perform any of the following operations, turn OFF the power supply to the NA Unit.
• When assembling a panel.
• When setting DIP switch.
• When connecting and wiring cables.
• When connecting or disconnecting the connectors.
After turning OFF the power, the Power Supply Unit may continue to supply power to the NA
Unit up to several seconds. The RUN indicator remains lit as long as the power is supplied.
Make sure that the RUN indicator is unlit before performing the operation as above.
3-2-1

Wiring Power Supply

Wire the power supply of the Power Supply Unit and the power terminal of the NA Unit.
AC Power Supply
Power Supply connector
Additional Information
This guide uses the Power Supply Unit, S8VS-06024. However, you can use any Power Supply
Unit that satisfies the specifications.
NA-series Programmable Terminal Startup Guide (V120)
_
+
3 Preparing in advance
3
3 - 3