About This Guide
This guide provides site preparation recommendations and step-by-step procedures to
install, remove, and replace the Alcatel-Lucent 16-port T1/E1 Any Service Any Port
(ASAP) Adapter card.
The 16-port T1/E1 ASAP Adapter card supports channelization down to DS0. Each port
supports TDM, Inverse Multiplexing over ATM (IMA), and multilink bundles over PPP
channels (MLPPP). A single 68-pin AMP connector on the faceplate provides access and
network connection for all ports.
Warning:
• All plugs must be properly crimped and conform to FCC Code of Regulations (CFR) Part
After the hardware installation process is completed, refer to the
Publications
Interface (CLI) information to configure system and network parameters.
List of Technical Publications
The 7705 SAR OS documentation set is composed of the following guides:
16-port T1/E1 ASAP Adapter Card Installation Guide
68, Subpart F. Failure to comply will result in damage to the jack.
for details on the boot process, software configuration, and Command Line
•
7705 SAR OS Basic System Configuration Guide
This guide describes basic system configurations and operations.
•
7705 SAR OS System Management Guide
This guide describes system security and access configurations as well as event
logging and accounting logs.
•
7705 SAR OS Interface Configuration Guide
This guide describes card and port provisioning.
Preface
List of Technical
Page 9