Sensor Update Interval
Sensor:
Rain
Wind
Temp/Humidity
Example: It does not rain everyday. When it is not raining the rain sensor will update every 3 minutes. When it is raining , the rain
sensor will updated every 45 seconds.
Sensor Search | Sensor ID
Each of your sensors has an individual ID number on the bar code of the
sensor. This sensor ID is visible on your station by pressing the SENSOR
button.
View ID numbers:
• Press and release the SENSOR button to view individual station and
sensor ID numbers. All other information will disappear temporarily.
Search for all sensors:
• While viewing sensor ID, hold the SENSOR button for 3 seconds to
search for all sensors.
• The station will search for all sensor ID numbers on the station.
• The sensor reception icon will flash for each sensor while searching.
• Allow up to 3 minutes to receive sensor signal.
Delete Sensor ID
In the rare event you need to replace your sensor, you will first need to
delete the old sensor ID from your station.
1. Press and release the SENSOR button to view your sensor ID number.
2. While viewing your sensor ID, hold the MINUS button for 5 seconds
to delete your old sensor ID. Dashes will show for the ID number.
3. Your station will search for a new sensor. Remove batteries from your
old sensor.
4. Install batteries in your new sensor and allow up to three minutes for
your new sensor readings and ID to appear on your station.
Note: When replacing your Thermo-hygro sensor, press the TX button
(under the battery cover) to send a signal immediately. The Rain and
Wind sensors do not have a TX button.
Professional Remote Monitoring Station
Change Required for Update
0.007 inch (0.2mm)
0.5 mph (0.8 km)
0.9F (0.5 C)
TX
C/F
Updates:
every 45 seconds
every 31.5 seconds
every 50 seconds
No Change- Sensor Updates:
every 3 minutes
every 3 minutes
every 3 minutes.
WIND SPEED
MPH
TOP
SPEED
1 HR
Page | 11
OUTDOOR