Mount The Lifter In Permanent Position; Use The Extender Arm To Stabilize Handset - Plantronics CS70 Series Setup Manual

6
. Check the Lifter height adjustment by moving the Lifter Height Switch to a higher position.
Repeat steps 2. through 4. as necessary.
If you hear a dial tone, the lifter height is now set correctly. Please continue with the next
section "Mount the Lifter in Permanent Position".
7
. If you still cannot hear a dial tone,
you will need to change the setting
on the Configuration Dial.
Using a coin or paperclip,
turn the Configuration Dial to
a different setting until you hear a
dial tone. Multiple settings might work
with your phone; however, only one is the
optimal position. If you still cannot hear a dial
tone, please call Technical Support
at 800-544-4660 Extension 5538.
To view an interactive set-up guide online, visit www.plantronics.com/cs70setup
and click on Compatibility.
Use the Extender Arm to Stabilize
Handset (if needed)
If your handset falls off the phone base or
does not return to its cradle when lowered,
you will need to attach the Extender Arm to
the Lifter as described in the HL10 Additional
Parts Kit.
C. Mount the Lifter in permanent position
1
. Remove the protective strips from the three mounting tapes on the underside of the Lifter.
2
. place the Lifter on the desk phone in the optimum position as determined above.
gently
Test the Lifter to verify positioning by pressing the Call Control Button on your headset to
activate the Lifter and listen for a dial tone.
3
. Press to adhere the Lifter to the desk phone.
firmly
Questions?
Peel back
mounting tape
protective strips
(3 places)
For fast, efficient Technical Support call:
Configuration
Dial
Position Indicator
800-544-4660 Ext. 5538