General Information; Parksense Rear Park Assist; Parksense Sensors; Activation/Deactivation Parksense - Jeep 2018 GRAND CHEROKEE User Manual

General Information

The following regulatory statement applies to
all Radio Frequency (RF) devices equipped in
this vehicle:
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-
exempt RSS standard(s). Operation is sub-
ject to the following two conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly ap-
proved by the party responsible for compli-
ance could void the user's authority to oper-
ate the equipment.
176
PARKSENSE REAR PARK
ASSIST

ParkSense Sensors

The four ParkSense sensors, located in the
rear fascia/bumper, monitor the area behind
the vehicle that is within the sensors' field of
view. The sensors can detect obstacles from
approximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear fascia/
bumper in the horizontal direction, depend-
ing on the location, type and orientation of
the obstacle.

Activation/Deactivation ParkSense

ParkSense can be enabled and disabled with
the ParkSense switch .
When the ParkSense switch is pushed to
disable the system, the instrument cluster
display will show the "PARKSENSE OFF"
message for approximately five seconds.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Panel in
the Owner's Manual at www.mopar.com/
en-us/care/owners-manual.html (U.S. Resi-
dents) or www.owners.mopar.ca (Canadian
Residents) for more information. When the
gear selector is moved to REVERSE and the
system is disabled, the instrument cluster
display will show the "PARKSENSE OFF"
message for as long as the vehicle is in
REVERSE.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service.
The ParkSense switch LED will be off when
the system is enabled. If the ParkSense
switch is pushed, and the system requires
service, the ParkSense switch LED will blink
momentarily, and then the LED will be on.

Instrument Cluster Display

The ParkSense Warning screen will only be
displayed if Sound and Display is selected
from the Customer - Programmable Features
section of the Uconnect System. Refer to
"Uconnect Settings" in "Multimedia" in the
Owner's Manual at www.mopar.com/en-us/
care/owners-manual.html (U.S. Residents) or
www.owners.mopar.ca (Canadian Residents)
for further information.