Electrolux EHL4CN User Manual page 11

6.2 Setting the time. Changing
the time
You must set the time before you operate
the oven.
The flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer
is not set.
In case of a power cut up to
1 hour, the time of day is
shown and
sure that the time is correct
and press
flashing.
In case of a power cut longer
than 1 hour, you must set the
time again.
Press the or to set the correct time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
To change the time of day press
and again until starts to flash.
6.3 Setting the DURATION
1. Set an oven function and temperature.
2. Press again and again until
starts to flash.
3. Press or
time.
The display shows
4. When the time ends,
an acoustic signal sounds. The
appliance deactivates automatically.
5. Press any button to stop the acoustic
signal.
6. Turn the knob for the oven functions
and the knob for the temperature to
the off position.
6.4 Setting the END
1. Set an oven function and temperature.
2. Press
again and again until
starts to flash.
3. Press or
The display shows
flashes. Make
to stop the
again
to set the DURATION
.
flashes and
to set the time.
.
4. When the time ends,
an acoustic signal sounds. The
appliance deactivates automatically.
5. Press any button to stop the signal.
6. Turn the knob for the oven functions
and the knob for the temperature to
the off position.
6.5 Setting the TIME DELAY
1. Set an oven function and temperature.
2. Press again and again until
starts to flash.
3. Press or
DURATION.
4. Press .
5. Press
or
END.
6. Press to confirm.
Appliance turns on automatically later on,
works for the set DURATION time and
stops at the set END time. At the set time
an acoustic signal sounds.
7. The appliance deactivates
automatically. Press any button to
stop the signal.
8. Turn the knob for the oven functions
and the knob for the temperature to
the off position.
6.6 Setting the MINUTE MINDER
1. Press again and again until
starts to flash.
2. Press
or
time.
The Minute Minder starts automatically
after 5 seconds.
3. When the set time ends, an acoustic
signal sounds. Press any button to
stop the acoustic signal.
4. Turn the knob for the oven functions
to the off position.
6.7 Cancelling the clock
functions
1. Press the again and again until the
necessary function indicator starts to
flash.
2. Press and hold
ENGLISH
flashes and
to set the time for
to set the time for
to set the necessary
.
11