Entering Programming Mode - Rae RAEGuard 2 PID User Manual

9.1

Entering Programming Mode

Enter Programming Mode by using the magnetic key to press these
buttons in sequence:
1. Press [+].
2. Press [-].
3. Press [MODE].
The password screen appears, with the cursor on the first digit:
Input the 4-digit password:
• Increase the number from 0 through 9 by pressing [+].
• Step from digit to digit using [-].
• Press [MODE] when you are done.
If you make a mistake, you can cycle through the digits by pressing
[-] and then using [+] to change the number in each position.
Note: The default password for Basic Mode is 1111.
The default password for Advanced Mode is 1250.
Once you enter Programming Mode, the LCD displays the first menu,
Calibration. Each subsequent menu is accessed by pressing [-]
repeatedly until the desired menu is displayed. To enter a submenu of
a menu, press [+].
The Calibration label is shown and its icon is highlighted, but you can
press [-] to step from one programming menu to the next, with the
name of the menu shown at the top of the display and the
corresponding icon highlighted.
RAEGuard 2 PID User's Guide
24