Kyocera m9300 Basic Manual page 44

To exit Emergency mode:
1.
Tap End call to end a 911 call.
2.
Press , and then tap
Menu
.
Yes
Enhanced 911 (E911) Information
This device features an embedded Global Positioning
System (GPS) chip necessary for utilizing E911
emergency location services where available.
When you place an emergency 911 call, the GPS
feature of your device seeks information to calculate
your approximate location. Depending on several
variables, including availability and access to satellite
signals, it may take up to 30 seconds or more to
determine and report your approximate location.
Important:
Always report your location to the 911 operator
when placing an emergency call.
designated emergency call takers, known as
Public Safety Answering Points (PSAPs) may not
be equipped to receive GPS location information
from your device.
32 2A. Device Basics
Exit Emergency mode >
Some
In-Call Options
Once you initiate a call, you will see the following
onscreen options. Tap an option to select it.
to mute the microphone during an active call.
Mute
Tap again to unmute your device's microphone.
Mute
to route the device's audio through the
Speaker
speaker or the earpiece.
to route the device's audio through a
Bluetooth
connected Bluetooth device.
End call to end the call.
To send DTMF (Dual Tone Multi Frequency) tones
during a call, tap or flick
display the onscreen dialpad. Tap again or flick
( ) downwards to hide it.
Dialpad
WARNING:
Because of higher volume levels, do not place
the device near your ear during speakerphone
use.
Further options may be available by pressing
during a call:
to place a second call while putting the
Add call
current caller on hold.
( ) upwards to
Dialpad
Menu