Connect Router To The Network; Guidelines For Connecting Ports - Cisco NCS 5501 Hardware Installation Manual

Connect Router to the Network

•
•
•
•
•
•
•

Guidelines for Connecting Ports

Depending on the chassis and installed line cards, you can use Quad Small Form-Factor Pluggable Plus
(QSFP+), QSFP28, SFP, SFP+, and RJ-45 connectors to connect the ports on the line cards to other network
devices.
To prevent damage to the fiber-optic cables that can separate from their cables, Cisco recommends that you
keep the transceivers disconnected from their fiber-optic cables when installing the transceiver in the line
card. Before removing such a transceiver from the router, remove the cable from the transceiver.
To maximize the effectiveness and life of your transceivers and optical cables, do the following:
• Wear an ESD-preventative wrist strap that is connected to an earth ground whenever handling transceivers.
• Do not remove and insert a transceiver more often than is necessary. Repeated removals and insertions
• Keep the transceivers and fiber-optic cables clean and dust free to maintain high signal accuracy and to
Guidelines for Connecting Ports, page 33
Connect to the Console Port, page 34
Connect to the Management Ethernet Port, page 36
Creating the Initial Router Configuration, page 37
Installing and Removing Transceiver Modules, page 39
Connecting Interface Ports, page 48
Maintaining Transceivers and Optical Cables, page 49
The router is typically grounded during installation and provides an ESD port to which you can connect
your wrist strap.
can shorten its useful life.
prevent damage to the connectors. Attenuation (loss of light) is increased by contamination and should
be kept below 0.35 dB.
◦ Clean these parts before installation to prevent dust from scratching the fiber-optic cable ends.
C H A P T E R
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
4
33