Connect Router To The Network; Port Connection Guidelines - Cisco 8200 Series Hardware Installation Manual

Connect Router to the Network

•
•
•
•
•
•
•
•
•

Port Connection Guidelines

Depending on the chassis , you can use optical modules and RJ-45 connectors to connect the ports to other
network devices.
To prevent damage to the fiber-optic cables, we recommend that you keep the transceivers disconnected from
their fiber-optic cables when installing the transceiver in the line card. Before removing a transceiver from
the router, remove the cable from the transceiver.
To maximize the effectiveness and life of your transceivers and optical cables, ensure the following:
• Wear an ESD-preventative wrist strap that is connected to an earth ground whenever you handle
• Do not remove and insert a transceiver more often than is necessary. Repeated removals and insertions
• Keep the transceivers and fiber-optic cables clean and dust free to maintain high signal accuracy and to
Port Connection Guidelines , on page 25
Interfaces and Port Description, on page 26
Connecting a Console to the Router, on page 28
Create the Initial Router Configuration, on page 29
Connect the Management Interface, on page 31
Install and Remove Transceiver Modules, on page 32
Connect Interface Ports, on page 34
Maintain Transceivers and Optical Cables, on page 35
Verify Chassis Installation, on page 35
transceivers.
can shorten its useful life.
prevent damage to the connectors. Attenuation (loss of light) is increased by contamination and should
be kept below 0.35 dB.
• Clean these parts before installation to prevent dust from scratching the fiber-optic cable ends.
• Clean the connectors regularly; the required frequency of cleaning depends upon the environment.
In addition, clean connectors when they are exposed to dust or accidentally touched. Both wet and
dry cleaning techniques can be effective; refer to your site's fiber-optic connection cleaning
procedures.
C H A P T E R
Hardware Installation Guide for Cisco 8200 Series Routers
4
25