Mitsubishi LJ61BT11 User Manual page 79

(1) The network parameters other than operation setting, station No., mode and
(2) When changing the parameters and settings of master station or slave station,
(3) When changing the parameters and settings of slave station, change the
(4) For the automatic refresh parameter setting, set the start device only. Devices
(5) When setting X, Y, B, W, SB and SW as refresh devices, make setting so that
(6) When setting X and Y as refresh devices, set I/O numbers higher than the I/O
7 - 7
POINT
transmission speed are also valid when the programmable controller CPU is
switched from STOP to RUN.
stop the data link at the master station and then make the changes.
parameters of the master station along with the slave station change.
are automatically assigned up to the last station number including reserved
stations and occupied stations.
In the following system configuration example, the last station number is "12".
Therefore, total of remote I/O points is 384 (32
register points is 48 (4
to "X1000" and that of remote register (RWr) is set to "W0", the end devices will
be "X117F" and "W2F" respectively.
Station
number 1
Master station
(X/Y00 to 1F) Remote
I/O station
(occupies
1 station)
they do not overlap with the device numbers used on the other networks, etc.
numbers used for I/O modules and intelligent function modules.
12 = 48). If refresh device of remote input (RX) is set
Station
number 4
Station
Local station
number 2
(occupies
Remote
4 stations)
device station
(occupies
2 station)
7 PARAMETER SETTINGS
12 = 384) and total of remote
Station
number 9
Station
number 8
Intelligent
Reserved
device station
station
(occupies
(occupies
4 stations)
1 station)
7 - 7