Hardware Installation - Edimax AR-7288WnA Manual

2. Hardware Installation

1. Connect the ADSL line.
Connect the line port of the router of the device to the modem interface of a
splitter using a telephone cable. Connect a telephone to the Phone interface
of the splitter using a telephone cable. Connect the Line interface of the
splitter to your existing, incoming line.
The splitter has three interfaces:
 Line: Connect to a wall phone jack (RJ-11 jack).
 Modem: Connect to the ADSL jack of the device.
 Phone: Connect to a telephone set.
2. Connect the router to your LAN network.
Connect the LAN interface of the router to your PC, hub or switch using an
Ethernet cable.
3. Connect the power adapter to the router.
Plug one end of the power adapter into a wall outlet and connect the other
end to the 12V interface of the device.
The following diagrams show how to correctly connect the router, PC,
splitter and the telephone sets under two different configurations:
Configuration 1
0 shows the correct connection of the router, PC, splitter and the telephone
sets, with no telephone set placed before the filter.
Figure 1 –Connection diagram
(Without connecting telephone sets before the filter)
9