Cleanup - WAGNER Flexio 2000 Owner's Manual

CleANUP

when cleaning, use the appropriate cleaning
i
solution (warm, soapy water for latex materials;
mineral spirits for oil-based materials).
flUShiNG The UNiT
Special cleanup instructions for use with
flammable solvents (must have a flashpoint
above 100ºF (38ºC):
•
Always flush spray gun outside.
•
Area must be free of flammable vapors.
•
Cleaning area must be well-ventilated.
•
do not submerge turbine!
1.
unplug the power cord. loosen the material container
by 1/2 turn, but do not remove it. this will relieve any
pressure left over in the system.
pull the trigger so that the material inside the spray nozzle
drains back into the container.
2.
unscrew the container and remove. empty any remaining
material back into the material container.
3.
pour a small amount of the appropriate cleaning solution
into the cup (water=1/2 full. mineral spirits=1/4 full).
4.
Attach the cup to the nozzle and plug in the sprayer.
5.
Spray the cleaning solution into a safe area.
while spraying, gently shake the spray gun. this slight
agitation will help break up smaller particles of spray
material.
6.
unplug the power cord. loosen the material container
by 1/2 turn, but do not remove it. this will relieve any
pressure left over in the system.
pull the trigger so that the material inside the spray nozzle
drains back into the container.
If you cleaned the sprayer using mineral
spirits, repeat steps 1-6 using warm, soapy
water.
Attention
12
1
2
4
6
eN
PULL
1/2
3
5
eMPTY wASTe
CoNTAiNeR
PULL
1/2
Move on to "cleanup - cleaning
the nozzle", next page.