Add/Edit A Qos Queue; The Class Setup Screen - Huawei B222s User Manual

9.3.1 Add/Edit a QoS Queue

Use this screen to configure a queue. Click Add new queue in the Queue Setup screen or the
Edit icon next to an existing queue.
Figure 48 Queue Setup: Add/Edit
The following table describes the labels in this screen.
Table 29 Queue Setup: Add/Edit
LABEL
Active
Name
Interface
Priority
Weight
Rate Limit
Apply
Back

9.4 The Class Setup Screen

Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port number,
destination port number or incoming interface. For example, you can configure a classifier to select
traffic from the same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the LTE Device forwards out through the WAN
interface. Give high priority to voice and video to make them run more smoothly. Similarly, give low
priority to many large file downloads so that they do not reduce the quality of other applications.
B222s User's Guide
DESCRIPTION
Select to enable or disable this queue.
Enter the descriptive name of this queue.
This shows the interface of this queue.
Select the priority level (from 1 to 7) of this queue.
The larger the number, the higher the priority level. Traffic assigned to higher
priority queues gets through faster while traffic in lower priority queues is dropped
if the network is congested.
Select the weight (from 1 to 15) of this queue.
If two queues have the same priority level, the LTE Device divides the bandwidth
across the queues according to their weights. Queues with larger weights get more
bandwidth than queues with smaller weights.
Specify the maximum transmission rate (in Kbps) allowed for traffic on this queue.
Click Apply to save your changes.
Click Back to return to the previous screen without saving.
Chapter 9 Quality of Service (QoS)
87