Huawei B222s User Manual page 46

Chapter 5 Wireless
Click Network Setting > Wireless to open the General screen. Select the Enable Wireless LAN
checkbox to show the Wireless configurations.
Figure 20 Network Setting > Wireless > General
The following table describes the labels in this screen.
Table 7 Network > Wireless LAN > General
LABEL
Wireless Network Setup
Wireless
Wireless Network Settings
Wireless
Network Name
(SSID)
Hide SSID
BSSID
Mode Select
46
DESCRIPTION
Select the Enable Wireless LAN check box to activate the wireless LAN.
The SSID (Service Set IDentity) identifies the service set with which a wireless
device is associated. Wireless devices associating to the access point (AP) must
have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the wireless
LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
This shows the MAC address of the wireless interface on the LTE Device when
wireless LAN is enabled.
This makes sure that only compliant WLAN devices can associate with the LTE
Device.
Select 802.11b/g/n to allow IEEE802.11b, IEEE802.11g and IEEE802.11n
compliant WLAN devices to associate with the LTE Device. The transmission rate of
your LTE Device might be reduced.
Select 802.11b/g to allow both IEEE802.11b and IEEE802.11g compliant WLAN
devices to associate with the LTE Device. The transmission rate of your LTE Device
might be reduced.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to
associate with the LTE Device. Select 802.11n only in 2.4G band to allow only
IEEE 802.11n compliant WLAN devices with the same frequency range (2.4 GHz) to
associate with the LTE Device.
B222s User's Guide