Table of Contents
Advertisement
LAN
100
(Port 1-4)
LAN
LNK/ACT
(Port 1-4)
1.5 Setup Diagram
Figure 1.2 below shows a typical setup for a Local Area Network (LAN).
1.6 Getting started
This is a step-by-step instruction on how to start using the router and get connected to the
Internet.
1) Setup your network as shown in the setup diagram above (fig 1.2).
2) You then need to set your LAN PC clients so that it can obtain an IP address automatically.
All LAN clients require an IP address. Just like an address, it allows LAN clients to find one
another.
Configure your PC to obtain an IP address automatically
By default XRT-401E's DHCP is on, this means that you can obtain an IP address
automatically once you've configured your PC to obtain an IP address automatically. This
section will show you how to configure your PC's so that it can obtain an IP address
ON
LAN port 100Mbps is connected
OFF
LAN port 10Mbps is connected
ON
LAN is connected
OFF
No LAN connection
Flashing
LAN port has Activity (ACT), data being sent
Figure 1.2
3
Advertisement
Table of Contents
