DeLonghi ESAM 04.110 Instructions Manual page 19

The coffee is delivered
too slowly or a drop at
a time.
Coffee does not come out
of one of the spouts.
The coffee does not come
out of the spouts, but
from around the service
door.
The frothed milk has
large bubbles
The milk is not frothed
Steam delivery stops
The appliance does not
come on.
When the steam/hot
water knob is turned to
the l position, steam/hot
water is not delivered
from the cappuccino
maker
The infuser assembly
cannot be removed for
cleaning.
The coffee is ground too finely.
The spouts are blocked.
The holes in the spouts are clogged with dry
coffee dust
Clean the spouts (A18) with a toothpick, spon-
ge or hard bristled kitchen brush (fig. 21 and
22)
The milk is not cold enough or is not
semi-skimmed.
Cappuccino maker (A9) dirty.
A safety device stops steam delivery after 3
minutes.
It is not plugged into the mains socket.
The main switch (A2) is not turned on.
The holes in the cappuccino maker (A9) and/or
steam nozzle (A10) are blocked
The appliance is on or has not completed the
turning off cycle.
Turn the grinding adjustment knob (A1) one click
clockwise towards "7" while the coffee mill is in
operation (fig. 7). Continue one click at a time until
coffee delivery is satisfactory. The effect is only visi-
ble after delivering 2 coffees (see the section "15.
SETTING WATER HARDNESS").
Clean the spouts (A18) with a toothpick (fig. 22).
The coffee guide inside the service door is blocked
and cannot swing.
Thoroughly clean the coffee guide (A19), particu-
larly near the hinges.
You should ideally use skimmed or semi-skimmed
milk at refrigerator temperature (about 5°C). If the
result is not as you wished, try changing brand of
milk.
Clean as described in the section "11.1 Cleaning the
cappuccino maker after use".
Wait, then activate the steam function again.
Plug into the mains socket.
Place the main switch in the I position (fig. 3).
Clean the cappuccino maker as described in the sec-
tion "11.1 Cleaning the cappuccino maker after use"
The infuser (A20) can only be removed when the
appliance has been turned off correctly (see the
section "6. TURNING THE APPLIANCE OFF").
19