Set Maximum Forward; Travel Speed (Stop); Neutral Function Adjustment - Walker T23 Operator's Manual

Maintenance Instructions
Set Maximum Forward Travel Speed (Stop) - Step 2
1. Position the FSC lever to the most FORWARD
position.
2. Turn the steering lever adjustment nut(s) until
2 or 3 threads are showing past the end of the
nut.
3. Loosen the jam nut at the other end of the control
rod (where it connects to the transmission con-
trol arm).
4. For each steering lever, use a wrench on the ad-
justment nut, turn the control rod counterclock-
wise (CCW) until the steering lever begins to
move backward, then make two additional turns.
Next, reverse and turn the control rod clockwise
(CW) until the steering lever stops moving for-
ward and then make one additional turn.
Tighten the jam nut.
NOTE: Failure to make at least one extra turn
on the control rod can place excessive loads on
the transmission internal control stops and
cause internal wear and damage to the transmis-
sion. Making additional turns beyond one turn
reduces the maximum forward travel speed.
Transmission
Control Arm
Transmission Control Rod and Arm Location
(Front Body Hidden for Clarity)
82
Jam Nut
Adjustment Control
Nut Rod
Control
Rod
Adjustment Nut
(2 or 3 Threads
Jam Nut
Showing)
Adjustment Components
Neutral Function Adjustment - Step 3
1. Securely block the tractor up so the drive tires
are off the ground.
2. Move the FSC lever to the NEUTRAL-PARK po-
sition (rear travel limit).
3. Start the engine (operate first at idle and then
normal operating speeds) and check for move-
ment of the drive wheels.
NOTE: If the engine will not start, check the op-
eration of the neutral safety switch.
CAUTION
NEVER attempt to disconnect any safety
devices or defeat the purpose of these
safety devices.
ADJUSTMENTS
Transmission
Control Arm