Table of Contents
Advertisement
Installation
This chapter describes the installation procedure for integrating the FT-2980R into a
typical amateur radio station. It is presumed that you possess technical knowledge and
conceptual understanding consistent with your status as a licensed radio amateur. Please
take some extra time to make certain that the important safety and technical requirements
detailed in this chapter are followed closely.
Preliminary Inspection
Inspect the transceiver visually immediately upon opening the packing carton. Confirm
that all controls and switches work freely, and inspect the cabinet for any damage. Gently
shake the transceiver to verify that no internal components have been shaken loose due
to rough handling during shipping.
If any evidence of damage is discovered, document it thoroughly and contact the shipping
company (or your local dealer, if the unit was purchased over-the-counter) so as to get
instructions regarding the prompt resolution of the damage situation. Be certain to save
the shipping carton, especially if there are any punctures or other evidence of damage
incurred during shipping; if it is necessary to return the unit for service or replacement, use
the original packing materials but put the entire package inside another packing carton, so
as to preserve the evidence of shipping damage for insurance purposes.
Installation Tips
To ensure long life of the components, be certain to provide adequate ventilation around
the cabinet of the FT-2980R.
Do not install the transceiver on top of another heat-generating device (such as a power
supply or amplifier), and do not place equipment, books, or papers on top of the FT-
2980R. Avoid heating vents and window locations that could expose the transceiver to
excessive direct sunlight, especially in hot climates. The FT-2980R should not be used in
an environment where the ambient temperature exceeds +140 °F (+60 °C).
FT-2980R Operating Manual
9
Hide quick links:
Advertisement
Table of Contents
