Connecting A Printer - Buffalo TeraStation 1000 User Manual

8
Configure the desired settings, then click OK.
Notes:
• If the TeraStation is connected directly to a UPS, select "Sync with UPS connected to this TeraStation". If a different
TeraStation is connected to the UPS, select "Sync with UPS connected to another LinkStation or TeraStation on
the same network". After making this selection, enter the IP address of the TeraStation that will be the sync source
in "Other LinkStation or TeraStation's IP Address".
• When the TeraStation is rebooted after an automatic shutdown (such as from a power outage or power supply
problem), verify that the power supply has been restored. If the TeraStation is turned on while it is still running on
the UPS and without the power supply restored, automatic shutdown is not performed, even after the specified
time has elapsed.
• If the power supply from the UPS to the TeraStation is stopped and restarted when UPS recovery is enabled, the
TeraStation is automatically restarted.

Connecting a Printer

You can connect a printer to the USB port on the TeraStation.
Notes:
• Only one USB printer can be connected to the TeraStation.
• Bidirectional communication is not supported i.e., remaining ink quantities and other printer status information is
not displayed.
• If a multifunctional printer is connected, only the printer function can be used. Other functions such as scanning
will not be available.
• The print server does not support macOS.
• Don't disable the SMB protocol while the print server is enabled. If you do, you will need to enable SMB again and
reconfigure the print server from scratch.
1
In Settings, click Services.
90