Restoring Factory Defaults; Initializing With Function Button - Buffalo TeraStation 1000 User Manual

4
From "Target USB drive", select the USB drive that is connected to the USB 2.0 port on the TeraStation.
5
Select "Transfer settings from a USB drive", then click Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
Note: Do not press the function button while applying settings from the USB drive.
7
When the "finished" message is displayed, applying settings is finished. Click OK.
Applying with Init Button (For TS1400D and TS1400R Models)
1
Turn off the TeraStation.
2
Connect the USB drive with the saved settings into a USB 2.0 port (not a USB 3.0 port) on the TeraStation.
3
While holding down the init button on the back of the TeraStation, press the power button.
4
Hold down the init button until the function LED glows. When it glows, let go of the button.
5
When the TeraStation is ready, the I41 message will be displayed in NAS Navigator2. For TS1400D models, the
power LED will start blinking red. For TS1400R models, the error LED will start blinking red.
6
Hold down the function button until the TeraStation beeps. Applying settings will start.
7
It will take several minutes for the settings to apply. When finished, the TeraStation will shut down.
8
Remove the USB drive, then power on the TeraStation.

Restoring Factory Defaults

There are two ways to initialize the TeraStation. Follow one of the procedures below.

Initializing with Function Button

If you forget the admin username or password, or wrong IP address was configured accidentally, follow the
procedure below to initialize these settings.
Notes:
• The following settings will be initialized: admin username, admin password, IP address, and Ethernet frame size.
• To disable initializing the admin username and password, navigate to Management - Restore/Erase - Edit and
change "Restore factory default settings" to "Keep current settings". Be careful with this option! If this is selected
and you lose your admin password, you will not be able to reset it.
1
Turn off the TeraStation.
101