1
In Settings, click Drives.
2
Move the RAID scanning switch to the
3
Click
to the right of "RAID Scanning".
4
Click Edit.
5
Select when to run the scan and click OK.
Notes:
• Select the "Immediately" checkbox to run a RAID scan immediately.
• To stop a RAID scan, click Cancel RAID Scan.
• If a RAID scan is configured to start while the TeraStation is in sleep mode, the RAID scan will not run.
Adding an External Hard Drive
Connecting an External Drive
Your TeraStation includes USB ports (the number of ports depends on your model), and you can connect external
drives to these ports. Once connected, they appear as shared folders on the TeraStation. Formatted drives are
detected automatically. Unformatted drives should be formatted in Settings.
After a USB drive is recognized, Windows adds "usbdisk x" under the TeraStation in "Network", where "x" is the USB
port where the hard drive is connected.
Compatibility
The following USB devices are supported by the TeraStation:
• USB storage devices
• Card readers (except for card readers that can recognize two or more memory cards)
Buffalo external USB drives are recommended but DUB and DIU series drives are not supported.
position to enable RAID scanning.
40