Table of Contents
Advertisement
2
In Settings, click Management.
3
Click
to the right of "Restore/Erase".
4
From "Target USB drive", select the USB drive that is connected to the USB 2.0 port on the TeraStation.
5
Select "Save current configuration to a USB drive", then click Execute.
6
The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.
7
When the "finished" message is displayed, saving settings is finished. Click OK.
Troubleshooting:
If the settings are not saved to the USB drive successfully, you may receive the error message "The specified
operation cannot be executed.". Verify:
• The USB drive has a capacity of 1 GB or larger.
• The USB drive is not write-protected.
Note: If you changed any hostname or network settings since your last backup, save your settings to the USB drive
again.
Applying Settings
The saved settings can be applied to a different TeraStation of the same series. If applying settings to another
TeraStation, the unit's current firmware version will be changed to the version used to save the settings.
There are two ways to apply settings from the USB drive.
Applying from Settings
1
Connect the USB drive with the saved settings into a USB 2.0 port (not a USB 3.0 port) on the TeraStation.
2
In Settings, click Management.
3
Click
to the right of "Restore/Erase".
100
Hide quick links:
Advertisement
Table of Contents
