Mount As Network Drive - Buffalo TeraStation 1000 User Manual

Name
TeraStation Name
Refresh
Browse Shares
Exit
*"I'm here" is available on TS1400D and TS1400R models. When clicked, the TeraStation will beep and its power,
function, and drive status LEDs will blink red.
The following tasks may be performed from the TeraStation's properties page.
Name
Configuration
IP Address

Mount as Network Drive

You can easily map a shared folder as a network drive using NAS Navigator2.
Browse Shares
Settings
Properties
Map Share
Disconnect Share
Create Shortcut
I'm here
*
Description
Opens the TeraStation's shared folder "share".
Opens Settings for the selected TeraStation.
Opens the TeraStation's properties page.
Assigns the TeraStation's shared folder as a network drive.
Unmaps the network drive.
Creates a shortcut icon on the desktop to the shared
folder "share".
Causes your TeraStation to beep.
Refreshes list of NAS devices on the network.
Shows a list of shared folders on the selected NAS device.
Exits NAS Navigator2.
Description
Click Settings to open the configuration interface.
Check Use DHCP to assign an IP address from the DHCP
server automatically. If there is no DHCP server on the
network, you cannot use this function. Check Renew IP
address to obtain an IP address from the DHCP server.
Uncheck Use DHCP and enter an IP address, subnet mask,
and default gateway to manually configure them.
112