Table of Contents
Advertisement
2.9.5
DIP Switch Configuration
The DIP switches are used to select the configuration settings listed in Table 2-10, and are located on the
right side of the unit next to the SD card slot as shown in Figure 2-2.
Figure 2-2 SD Card Slot and DIP Switch Locations
2.9.5.1 GMA 245 DIP Switch Configuration Settings
The GMA 245 DIP switch configuration settings are listed in Table 2-10.
top cover of the unit, the down switch position is ON, the up switch position is OFF.
Table 2-10 GMA 245 DIP Switch Configuration Settings
Switch
Function
ENABLED KEYED
1
ICS
PILOT IN RIGHT
2
SEAT
MUTE ON COM
3
TX
4
RESERVED
5
RESERVED
6
RESERVED
7
RESERVED
CONFIGURATION
8
LOCKOUT
190-01879-11
Rev. 6
SD CARD SLOT
SD CARD SLOT
DIP SWITCHES
DIP SWITCHES
When set to ON, the intercom system (ICS) will only allow intercom
MIC audio to be heard when the corresponding ICS KEY for the MIC
position is pressed. When set to ON, auto squelch will NOT be active.
This setting is for intercom 3D audio. Normally the Pilot will be
positioned to the left in the Copilot's headset, and the Copilot will be
positioned to the right in the Pilot's headset. When set to ON, this
setting reverses that so the Pilot is positioned to the right in the
Copilot's headset, and the Copilot is positioned to the left in the Pilot's
headset.
When set to ON, the monitored COM radio is muted during mic-
selected COM transmission (mic-selected COM is still heard, but not
the monitored COM radio).
LEAVE SWITCH IN OFF POSITION
LEAVE SWITCH IN OFF POSITION
LEAVE SWITCH IN OFF POSITION
LEAVE SWITCH IN OFF POSITION
When set to ON, this prevents use of the GMA 245's config mode UI.
When installed in a G3X Touch system, this setting prevents the use of
the GMA 245's config mode UI, but it does not prevent an integrated
G3X Touch system from configuring the unit.
Per the label attached to the
Description
GMA 245/245R Installation Manual
Page 2-7
Hide quick links:
Advertisement
Table of Contents
