Display Cable And Webcam Cable - HP OMEN Maintenance And Service Manual

Display cable and webcam cable

NOTE: The display cable and webcam cable are spared together in a kit.
Description
Display and webcam cable for use only on models equipped with an ultra high definition (UHD) panel and
infrared webcam
Display and webcam cable for use only on models equipped with an ultra high definition (UHD) panel and
standard webcam
Display and webcam cable for use only on models equipped with an full high definition (FHD) panel and
infrared webcam
Display and webcam cable for use only on models equipped with an full high definition (FHD) panel and
standard webcam
IMPORTANT:
and replacement
Before removing the display cable and webcam cable, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Hinge covers (see
b. System support brackets (see
c. Heat sink (see
d. System board (see
e. Display assembly (see
f. Display bezel (see
g. Display panel (see
Remove the display cable and webcam cable:
1. Release the webcam cable from the clips securing it to the back cover (1).
Make special note of each screw and screw lock size and location during removal
Battery on page
Hinge covers on page
Heat sink on page
System board on page
Display assembly on page
Display bezel on page
Display panel on page
33), and then remove the following components:
48).
System support brackets on page
56).
61).
65).
70).
76).
Spare part number
929454-001
929453-001
929452-001
929451-001
49).
Component replacement procedures 79