How To Connect Your Receiver - ViewSat VS9000HD Troubleshooting Manual

(1) HOW TO CONNECT YOUR RECEIVER: REAR PANEL:
1. Satellite IN Connect RG6 Cable.
•
2. Loop-Out
•
• 3. UHF Remote Antenna Module
4. Serial Port
•
• 5.
USB Port
6. HDMI Output
•
7. SPDIF Digital Output
•
NOTE: When 8PSK Card is used RG6 Cable connects between 3 and 2 this allows HD with US
Providers.
NOTE: With Revision 1 VS9000HD unit here is only one port showing as I have shown , Revision 2
has two ports for the UHF Module insert.
(2) 8PSK CARD INSTALLATION AND CONNECTION:
1. Remove the cover and face the front towards you.
•
2. is is Important GROUND your self or DISCHARGE any static electricity by touching METAL
•
before you continue.
3. e 8PSK Module come with two cables one black one white and they will only connect to their
•
connectors, you can not cross them.
4. Remove the UHF Remote Antenna Module and replace it with the 8PSK Module.
•
5. Connect the black cable to the connector at the bottom side of the 8PSK to connector of MLB
•
(main logic board) connect the white cable 8PSK to the top/left connector of the MLB.
Replace the cover.
•
Complete Installation guide go to:
VS9000HD 8PSK UHF Adapter Module:
VIEWSAT 9000HD User Troubleshooting Guide & Manual. April /2008
/ Replace with 8PSK Module
http://www.youtube.com/watch?v=0QB58hjyjXA
Document page.2