TomTom BANDIT Reference Manual page 26

5. Move up or down to turn it on.
Note: When connecting the camera to the remote control for the first time, any button press on
the remote control tells the camera that the remote control is out there and ready for connec-
tion.
Tip: The Viewfinder of the Mobile App also has remote control features – see MOBILE APP.
The remote control can control up to 50 cameras simultaneously from up to 180m in optimal
conditions. It has a small LCD screen which mirrors what is shown on the Camera Status screen.
The remote control can only be used with one camera at a time. If you want to connect your remote
control to a different camera, repeat the instructions above with the remote control in range of the
new camera.
Note: To change settings on the camera using the remote control, the camera needs to be in
Wi-Fi mode.
Changing the battery in the remote control ***THIS SECTION WAS MADE UP BY CLAIRE!!!***
The remote control uses a button cell CR2032 battery.
To change the battery do the following:
1. Using a small flat-head screwdriver, gently lever the back off the remote control.
2. Gently lever out the round battery cell.
3. Replace the battery with a new one.
4. Replace the cover and snap it back into place on the remote control.
Using the remote control to record a movie
Press the START button (button 2) to start recording. The LED (3) blinks red when the camera is
recording.
Press the START button (button 2) to tag any exciting moments.
To wake up the remote, press the START button (button 2) for 2 seconds until the LED (3) blinks
twice in green.
Squeeze the remote, ie. press the STOP button (button 1) to stop recording. The LED (3) stops
flashing red.
Remote control straps and mounts
The remote control is supplied a strap which will fit both around your bare wrist and around a
winter coat during snow sports. Other straps are available, as well as mounts for handlebars and
dashboards.
Tip: The remote control is waterproof to a depth of 3 m.
26