Miele KM 6310 Operating And Installation Instructions page 47

Problem
Power setting 9 is
automatically reduced if
you select power
setting 9 on two linked
burners or extended
zones at the same time.
Auto Heat-up is turned
on, but the food does
not start cooking.
A noise can be heard
after the appliance is
turned off.
One or more residual
heat indicators is
flashing.
The sensor buttons are
over-sensitive or do not
react at all.
Possible cause and remedy
Operating both zones at power level 9 would exceed
the permitted maximum power for the cooktop.
 Use another burner that is not linked.
Large amounts of food are being heated.
 Start cooking at the highest power level, then
reduce the power level manually.
Pan is not conducting heat properly.
 Use a different pan that is able to better conduct
heat on an induction cooktop.
The fan will continue running until the appliance has
cooled down. It will then turn itself off automatically.
There was a power failure during operation or when
residual heat was present.
You called the programming function while residual
heat was still present.
The sensitivity level of the sensor buttons has
changed.
 Make sure that there is no direct light (from the sun
or from an artificial source) falling onto the
cooktop. The area surrounding the cooktop must
not be too dark.
 Make sure that there is nothing covering the
sensor buttons or the cooktop.
Take any pans off the cooktop and wipe away any
food deposits.
 Interrupt the power supply to the cooktop for
approx. 1 minute.
 If the problem persists after power is restored,
please contact Miele Service.
Problem solving guide
47