Miele KM 6310 Operating And Installation Instructions page 46

Problem solving guide
Problem
In the burner display,
the  symbol will flash
alternately with the
selected power setting
or .
After the cooktop is
activated,  appears in
the timer display for
several seconds.

flashes in the
timer display and
the cooktop
turns off
automatically.
After turning on the
cooktop,  appears in
the timer display for
several seconds. The
cooking zones don't
heat up.
A burner turns itself off
automatically.
A cooking zone or the
whole cooktop turns off
automatically.
The booster has
automatically turned off
early.
The burner is not
working in the usual
way with the set power
level.
46
Possible cause and remedy
There is no or unsuitable cookware on the cooking
zone.
 Use a suitable pan (see "Cookware").
The system lock or safety lock is activated.
 Deactivate the system lock or safety lock (see
"System lock/Safety lock").
One or more of the sensor buttons are covered, for
example by fingers, food boiling over or by an object.
 Clean off any dirt or remove the object (see
"Safety shut-off").
The cooktop is in demo mode.
 Deactivate demo mode (see "Programming").
A burner might have been operated for too long.
 You can use the burner again by turning it back on
(see "Safety shut-off").
The overheat protection was triggered.
 See "Overheat protection".
The overheat protection was triggered.
 See "Overheat protection".
The overheat protection was triggered.
 See "Overheat protection".