Secondary Shaft - Dnepr MT9 Repair Manual

Re-assemble th e shaft· in reve rse order, lhe only difference being
that lhe third speed gear is first pressed on not to the
full
extent,
but to that part of lhe shaft whose outer diameter is sma ll er, so that
the gear is free to rotate on the shaft. Insert the key into the shaft
slot and press on t he fourth speed gear until it is en gaged with the
end face teeth of the third gea r, following w hi ch press the both gears
home.
Press on the bearing, fit the paperboard gasket oncl th en the gland
co upling.
A-A )
Fig. 26. Casing assembly:
I - gland
to be press-iitted flush. Prolruding or dipping of gland is not more
lhan 0 2 mm: / / - s lol to be lo\ated in vei!ical plane ±3°
Secondary Shaft
Di smantle the secondary shaft in the following order:
If
required, in case the bear in gs remain on the shaft, press out
the sp lin ed end of the shaft from bearing No . 304, us in g an appli-
ance Tip-1674 for the purpose.
Remove th e rear \vasher, adjusti ng shims, if the latter we re fit-
ted during assembly, and the reve rse gea r.
80