Harman Stove Company Accentra-2 Installation And Operating Manual page 6

lanitor Switch to "MANUAL"
Room Temperature Mode
The fire will have to be lit with starting gel and a
match, or started automatically, see "Automatic Opera-
tion". Turn to "Manual" position when the fire is estab-
lished.
' T he difference between "AUTO Room Tempera-
ture Mode and "Manual" Room Temperature Mode is
that the fire will not go out as the roam temperature goes
above the control board setting. The unit can only go to
Room Temperature ~ ~ d ~ : setting will produce a room
(OW
burn andwill remain there until it runs out of fuel or
temperature of 70 degrees with the distribution blower at medium
until more heat is needed and the feed rate increases.
speed.
Feed rate adjustments and dial settings are the same
as "AUTO settings.
The Accentra Pellet Stove is capable of manual operation. This also allows the opera-
OFF
*&@ic
+d
@ @
0
0
IGNITOR
AUTO
FEED
0
MOTOR
tor to manually control operation during an emergency (i.e. igniter failure, when using a
502H battery backup, or when using certain generators.)
COMBUSTION
0
BLOWER
The unit can be switched between "AUTO and "MANUAC' at any time during operation.
E -
::z
- o m
NOTE: When starting the unit in the "AUTO"
mode and switching to "MANUAC', the fire must be
large enough to start the distribution blower. The
starting of the blower is a signal that the start cycle
is completed and the fire will not go out.
DISTRlBUTlON
0
BLOWER
0
STATUS
0
POWER
WARNINC:
HIGH
M L m G E
D l a m m u e d pomr b d m 0penbg
O D V m .
This setting will produce a lawe viewing fim without a
distribution blower operating.
Fia. 6
lnnitor Switch to "MANUAL"
Stove Temperature Mode
' T he advantage of this mode is to allow the opera-
tor to have a largeviewing fire without blowing extra heat
into the room.
During operation, with the temperature dial set at
#5 or less, the distribution fan will not operate. A#5 on
the temperature dial and a #5 on the feed adjuster is
approximately 80% output. It is not necessary to oper-
ate the distribution blower below this point. Therefore,
there can be a higher feed rate ( a larger v i e w i n g fire)
without an excess of hot air blowing into the room.
An example of when to use the Manual Stove Tem-
perature Mode is if you want to watch a large fire and
the room is aleady up to temperature. The Stove Tem-
perature Mode allows you to have a larger fire and a
lower sound level, without the distribution blower.
NOTE: During the use of this mode, if you keep
increasing the temperature dial setting to increase
the fire size, the distribution blower will automati-
cally come on when the ESP Temperature reaches
350° F, or 81 % output.