Harman Stove Company Accentra-2 Installation And Operating Manual page 21

1. Remove the two heat exchanger covers. See Fig.
35. These covers are made of cast iron and are held
into place with a swing latch in the upper right and
left corners. See Fig 36. Swing the latch upward far
enough to release the top edge of the heat
exchanger cover. Tilt the cover forward
approximately 2" and lift it upward about 1
"
to release
the bottom edge. The cover can now be taken
completely out through the upper door opening.
Repeat the process with the second heat exchanger
cover.
I
'
Possible pellet fines buildup area.
I
I
This chamber may get a buildup of fines from the
feeder mechanism movement. This area should be
checked and cleaned at least once a year.
To remove the feeder cover:
Remove the 511 6" wing nut.
Slide the cover off of the threaded stud.
Inspect and clean the inner chamber if necessary.
See above picture.
Reinstall the cover making certain it is centered on
the feeder body and tighten as tightly as you can by
hand.
Fig. 35