Electrical System (12-V Dc); Lights; Circuit Breakers; Wiring And Connections - Hobart 140GT17P Operation And Maintenance Manual With Illustrated Parts List

3. Electrical System (12-V DC)

A. Lights
Check all lights for proper operation DAILY. Replace any defective lamps (bulbs) as soon as discov-
ered. Figure 2 lists ALL lamps, their location, and part numbers.
Light
Identification
Instrument Panel

Lights

Engine ON Indicating
Light
Contactor CLOSED
Indicating Light
Fault Indicating
Lights
Clearance Lights
B. Circuit Breakers
All engine and generator circuit components except the voltage regulator are protected with one of
three circuit breakers located on the engine-generator control panel. See Figure 3 for circuit breaker
ratings and items protected by the respective circuit breaker. Replace defective circuit breaker (s) as
necessary, if one or more circuit breaker (s) is stuck open or will not open for an overload condition.
C. Wiring and Connections
(1) Inspect all cables and leads for broken, worn, and damaged insulation.
(2) Check electrical connections for looseness.
NOTE: A darkened terminal generally indicates a loose connection.
September 30/89 Revised
Location
Generator & Eng. Lamp Industry
Control Panel
Engine Control
Panel
Engine Control
Panel
Generator
Control Panel
Canopy
Lamp Identification Chart
Figure 2
Lamp Lamp
Manufacturer Number
67
Trade No.
Lamp Industry 01-903.1
Trade No.
Lamp Industry 01-903.1
Trade No.
Lamp Industry 01-903.1
Trade No.
Lamp Industry 1895
OM-2029
2-2
Page 3