Hobart 140GT17P Operation And Maintenance Manual With Illustrated Parts List page 111

TROUBLE, SYMPTOM
AND CONDITION
PROTECTIVE CIRCUIT (CONTINUED)
2. Load contactor
opens during power
delivery. Under-
voltage indicating
light ON (Cont'd)
3. Load contactor
opens during power
delivery. Over-
frequency ind
cating light (DS40)
ON
September 30/89 Revised
PROBABLE CAUSE
B. Defective over-under
voltage module (K26)
C. Defective protective
monitor module (K14)
A. Electric governor
improperly adjusted,
or malfunctioning
(1) Governor improperly
adjusted
(2) Electric governor
system malfunctioning
B. Defective over-under-
frequency sensing
module (K27)
Trouble Shooting Chart (Sheet 17 of 20)
Figure 4
TEST, CHECK, AND/OR
REMEDY
B. Use rheostat to reduce
voltage to 104 V. The
undervoltage indicating
light should NOT come on
during a time delay of 4 to
12 seconds. If the light
comes on before a delay of 4
to 12 seconds, the under-
voltage relay is defective.
Replace the module (K26) or
the protective relay tray.
C. With unit running normally,
use rheostat to reduce
voltage quickly to
90 V. If the undervoltage
indicating light (DS38) is
turned ON immediately, the
protective monitor circuitry
is defective. Replace pro
tective monitor (K14) or replace
protective relay tray.
A. Proceed as follows:
(1) Adjust in accordance
with Sect. 2-3, Para. 3.
(2) Check and adjust or re-
pair in accordance with
ENGINE AND CONTROLS,
Troubles 8 and 9.
B. If overfrequency nuisance
tripping continues after the
governor system is proven to
be good, and an overfre-
quency condition does not
exist, replace the over-
OM-2029
3-1
Page 23