Warning Messages - Pitney Bowes J693 Operator's Manual

Warning Messages:

Displayed Message
(Continued next page)
J693
Description
The printer has
detected burned-
out printhead
elements.
The printer missed
detecting a label
gap.
Power has been
removed and
shutdown is in
progress.
The host has
pending
configuration
changes that will
not take effect until
a 'host reset
command' is
issued.
The printer has
detected a low
operating voltage.
Ribbon will soon
need replacement.
The printer was
unable to save
settings in
permanent
memory.
Action
Replace the printhead when
print quality becomes
unacceptable or if the
printed bar codes are non-
compliant.
Readjust the media sensor
and recalibrate.
The printer power switch
was turned 'Off', the line
fuse has blown, or AC line
voltage has been lost.
To save changes, send a
host reset command (in
DPL) or to discard changes
perform a front panel reset;
see Section 4.0.6.
A possible low or
fluctuating line voltage
level. Try moving the
printer to another outlet. If
this condition persists call
for service.
Replace ribbon when
needed.
If the condition persists,
possible faulty Main PCB.
Call for service.
73