Back Panel - Cisco ON100 Quick Start Manual

Back Panel

Slot or Connector Description
AUX
SD CARD
MON
LAN
RESET
On/Off Switch
POWER
Default Settings
Setting
LAN IP addressing
method
4
Not used.
Not used.
Monitoring port.
This port must only be used as documented for
specific Cisco OnPlus solutions. For more
information, see www.cisco.com/go/onplus.
LAN port with PoE.
If the LAN port to which you are connecting the
OnPlus Network Agent does not support PoE, use
the external power adapter supplied with the
device.
If held for less than 10 seconds, executes a safe
shutdown and restarts the OnPlus Network Agent.
If held for 10 seconds or more, initiates a factory
reset. See Resetting the OnPlus Network Agent,
page 12.
Power the OnPlus Network Agent On or Off.
Connector for the external power adapter, if used.
You can power the OnPlus Network Agent using PoE
or the external power adapter.
Default Value
DHCP (required for initial startup only).
At initial startup, the OnPlus Network Agent must
obtain a LAN IP address using DHCP.
Once you are connected to the OnPlus Network
Agent and have started the activation process, you
can assign a static LAN IP address to the device if
needed.
Cisco ON100 Network Agent Quick Start Guide