Actuator Mounting; Determining Mounting Position; Determining Closed Position; Parts Ordering - Fisher V260 Instruction Manual

V260 Valve
July 2017

Actuator Mounting

Use the appropriate actuator instruction manual when mounting the actuator or changing actuator styles and
positions.

Determining Mounting Position

The actuator can be either right‐ or left‐hand mounted.
Note
D
Right‐hand mounting means that the actuator is mounted on the right side of the valve when viewed from the valve inlet.
D
Left‐hand mounting means that the actuator is mounted on the left side of the valve when viewed from the valve inlet.
Right‐ or left‐hand mounting can change the actuator action from push‐down‐to‐close to push‐down‐to‐open, or
vice‐versa.

Determining Closed Position

1. You must remove the valve from the pipeline to check the position of the ball.
2. Adjust the actuator linkage or travel stops as described in the actuator instruction manual. Adjust the actuator so
that the valve ball will be fully open or closed when the actuator is at the end of its stroke, depending on the
actuator action selected.

Parts Ordering

A serial number is assigned to each valve and stamped on the nameplate. Always refer to the valve serial number when
corresponding with your
When ordering replacement parts, also specify the part name and desired material.
WARNING
Use only genuine Fisher replacement parts. Components that are not supplied by Emerson Automation Solutions should
not, under any circumstances, be used in any Fisher valve, because they may void your warranty, might adversely affect the
performance of the valve, and could cause personal injury and property damage.
12
Emerson sales office or Local Business Partner regarding spare parts or technical information.
Instruction Manual
D102178X012