Table of Contents
Advertisement
Section 5
Connecting
5.7
60
No damage will occur when the plug is inserted 180 degrees turned.
110-250 VDC
1
2
100-240 VAC
1
2
48-125 VDC
1
2
GUID-C2321B6B-3157-4F0A-AD25-ACE8E71C4462 V2 EN
Figure 32:
Connecting the auxiliary voltage connector
Connecting communication
Before connecting communication, check that the HW module has the correct
communication interfaces. The communication module is located at the bottom of
the IED for the 4U half 19" case and on the left side of the IED for the 6U half 19"
case when viewing the case from the rear.
See the technical manual for product-specific communication
interfaces.
The allowed minimum bending radius has to be checked from the
optical cable manufacturer.
Ethernet devices shall not be connected into rear HMI port. This
can damage IED or connected Ethernet device.
Correct / 180 degrees wrong
3
The input has a rectifier bridge
Correct
3
180 degrees wrong
3
No problem, contact open
1MRS755958 C
630 series
Installation Manual
Advertisement
Table of Contents
