Street Roller - Merlin 6-IN-1 DIY Educational Solar Toy Kit Instruction Manual

f) Take assembly 1 (which was made in the beginning) and
attach the Solar module to this arm (fig 10). Attach the arm to
the Gearbox unit and connect the wires from the Solar Module
to the Gearbox Module (Fig 11). Now connect the counter
weight module by sliding it in (fig 12).
Solar Module
WHITE WIRE
CONNECT
GREEN WIRE
CONNECT
Bottom View
Part
g) The final step for the flying bird is to attach it to the bottle.
Before you start half fill the bottle with water and place cap A15
onto it. (fig 13). Now place the coins in the counter balance
module and then put the entire assembly onto the bottle (fig
14). Adjust the counter balance module so the bird is level (fig
15). The bird will now fly around when placed in a sunny area
(fig 16).
Add Water
Plastic Bottle
Insert Coins
Part
White
Green
Green
White
Sliding
Adjust Part 2 to balance lever.
Running

6. Street Roller

For the street roller, you will require two cans of equal size and
some stiff paper or think cardboard.
Street Roller
Recycled Parts Required
Paper
Soda Can
330-355 ml
a) Start the street roller by connecting the Solar Module's
wires to the Gearbox. Now clip the Solar Module to the Gearbox
using the arm (fig 1). Attached the eyes and gear wheel to the
Gearbox Module (fig 2). This we will call Assembly one.
Solar
Module
Gear
Box
WHITE WIRE
CONNECT
CONNECT
GREEN WIRE
b) Attach the following pieces to make the bracket that will to
hold the cans (fig 3). This is called assembly two. Next assemble
the parts in fig 4 which gets attached to the bracket as shown
in fig 5. This would be called assembly three.
Assembly & Play
Same size required
10